Enoptech Hologram LED Fan Display Splicing Solutions

Link:http://www.enoptech.com

Backside of 3D FAN details

① AP/STA button------long press 2 seconds, reset into normal model

② AP/STA indicator light------normal model or Internet model

③ PAIR button------switch master & slave model, match remotecontrol

④ PAIR indicator light------power, on-off, model switch

⑤ Union socket 1------signal IN

⑥ Union socket 2------signal OUT

⑦ Power socket

Indicator light introduction

PAIR light
Red	Master model, motor stop
Pink	Master model, motor on
No light	Slave model, motor stop
Blue	Slave model, motor on
Blue flash	Matching remote control

AP/STA light
Green flash	Device is starting
Green long bright	Normal model
Blue flash	Internet model connecting
Blue long bright	Internet model successful set
Red flash	Internet model Error

Example: 4 units Multi-fans sync (65H)

Step 1: Installation

HTB1i.pJXDjxK1Rjy0Fnq6yBaFXa1.jpg

All distance is calculatedby the Pythagorean theorem, theoretical data, actual distance may have somedifference, adjust by actual situation.

Keep central distance 1145px of adjacent device.

One front one back, keep2-75px. Avoid led blade touch.

4 units.png 微信图片_20181115144220.jpg

Step 2:Connection

1. 3.5mm audio cable to connect all devices.Two sockets on backside, one signal in, one out, please follow diagram below.The order is very important, cannot mess.

WX20190425-001250@2x.png

2. Normally we set the first device as mastermodel, other switch into slave mode.

3. Master to Salve: long press PAIR button,till red light turns no light.